Saw your post, I am sorry I can answer. I am not as far ahead in NAT-PT as you. I am trying to do a simple example from CCO,but unable to get to work, when i try to ping from one side to the other and run debug ipv6 nat in the router running nat-pt, i get no translations found. Just so that I understand the logic correct, in your config:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.