Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT STATEMENT Help

I have two lines that I am using to get out to the internet. One is a 3G card we NAT all inside devices out with this command...

ip nat inside source list 110 interface Cellular0/0/0 overload

the 110 access list is a permit all

The other connection, which is our back-up line goes to a satellite modem via FA0/1 it's NAT statement is this...

ip nat inside source list 112 interface FastEthernet0/0 overload

Same thing on the ACL.

I also have 2 default routes...

ip route 0.0.0.0 0.0.0.0 Cellular0/0/0 99 track 1 (track command is to line-protocol on cell card)

ip route 0.0.0.0 0.0.0.0 1.1.1.1 100

Here's my question, If the Cellular card goes down and I want fa0/1 to pick-up and work as a secondary how would I do it? I thought having all these commands would cause it to work but I can shutdown the cellular card and fa0/1 will not pick up.

2 REPLIES
New Member

Re: NAT STATEMENT Help

I don't know if it would matter or not but I'm using a 2811 with advanced security IOS

New Member

Re: NAT STATEMENT Help

I don't know if it would matter or not but I'm using a 2811 with advanced security IOS

124
Views
0
Helpful
2
Replies