Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

nat static for a range of port

Hi,

We need to do a nat static, in a router, for a range of port.

Is there a simpler way than entering many "ip nat inside source static udp 192.168.x.x" to do that ?

1 REPLY
Silver

Re: nat static for a range of port

Static addresses should not be members of the global address pool.If the internal host requires Internet access, the static address should be a NIC-registered address.Refer the following URL for more information regarding this

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a00800eb730.html

160
Views
0
Helpful
1
Replies
CreatePlease login to create content