Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NAT Translation rule

Hi All,

We have a small setup with Cisco router, switch and some IP Phones.

I was wondering if we are able to create a NAT rule so that we can access the GUI of the IP phones from the remote network.

Please advise.

Much appreciate your help.

Thanks,

2 REPLIES
VIP Purple

NAT Translation rule

Hello

When you say remote network do you mean -outside your internal network ie: WAN/Internet

You should be able to nat any internal addressing to an outside address range - providing your router supports nat and also you have outside(global) address(es) to use.

Please provide  more detail on the devices involved and we may be able to assist you further.

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.

Please don't forget to rate any posts that have been helpful. Thanks.

NAT Translation rule

If u are reffering to access ip phones from any remote Public ip location.

Then u can do static nat

nat your Internet ips of phone with public IP.

in that case u will be able to access them globally.

Jawad

Jawad
116
Views
0
Helpful
2
Replies
CreatePlease to create content