Client is getting an internet in ethernet output with private ip ( 10.0.2.5/24 through 10.0.2.8/24 with proxy ip being 10.0.2.90 port 80 ) from their parent company,for accessing the internet the client needs to connect the output to switch and assigning the above given ip,proxy and port number to pc.
Can we terminate the smae Ethernet output to the router and make it do nating for the client LAN ( 192.168.10.0/24 )? and client should be able to browse internet without assigning any sort of proxy ip and port number in their pc.
Dynamic Nating or PAT could be done at the router.The router replaces the sending computer's non-routable IP address with the first available IP address out of the range of unique IP addresses.Refer URL for more info NAT
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...