Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

nat with vrf support

i have a PE # 2 router  connected to PE#1 router . i have already running a natting on the PE 2 router and everything is working fine .

now i want to create a vrf on the PE 2 router and i have created sub interface on fa 0/1.2 on PE 2 , now is it possible to enable both ip nat inside and ip vrf forwarding on fa 0/1.2 and only ip nat inside on fa 0/1.1 .

as i want vrf traffic to go through fa 0/1.2 and normal internet traffic to go through fa 0/1.1

any comments

.

443
Views
0
Helpful
0
Replies