Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NAT

Hi.

I'am using NAT.

I'd like to install server inside. Traffic with specific port number from outside have to be connected to inside server.

I opened this ports on access-list. but it's not established.

I think this traffic can't find inside server.

What should I do?

I really hope your advice.

Thanks.

6 REPLIES

Re: NAT

Hi

Can you post the config?

Regards

JD

New Member

Re: NAT

can u post your NAT configuration? it will help to troubleshoot.

New Member

Re: NAT

Thank you for your respone.

Sorry, I can't post it.

But I've solved it with "ip nat inside source static" command.

Here I have one more question.

If I used that command, I can make mapping to specific inside server.

But Is there other solution in order to traffic from outside can find inside destination itself?

Thanks.

Re: NAT

Hi

Its good to note that you have solved the problem yourself.

There is no solution for this, you need to have the config. done in your router.

http://www.ietf.org/rfc/rfc1631.txt

http://www.cisco.com/warp/public/556/nat-cisco.shtml

Regards

JD

New Member

Re: NAT

U need to configure dynamic nating for this

Re: NAT

Hi

I believe that Dynamic NATing is valid only when the first initiation takes from internal network.

In case of servers in internal networks, they do not initiate a connection, the outside network initiates the connection.

Hope that helps.

Pls rate helpful posts.

Regards

JD

115
Views
0
Helpful
6
Replies
CreatePlease to create content