Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

native vlan mismatch

I have a test lab, setting up a UC540 and a catalyst 2960 and every minute or two I get native vlan mismatch discovered, ect ect. Is there a way I can just turn this off for now while I am in the process of updaiting the config?

1 REPLY
Hall of Fame Super Blue

Re: native vlan mismatch

Raymond

Native vlan mismatch errors are usually reported by CDP so if you disable CDP on the trunk interface you should stop seeing those messages.

Obviously, as i am sure you are aware, you do need to match the native vlan on both ends of the trunk link when you go live.

Jon

173
Views
0
Helpful
1
Replies