Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NATTING a destination address?

folks

another post!

i have a connection into a 3rd party lan through my firewall and i need to open a connection into the 3rd party but i have a problem - they're using a network range i use

i think nat would allow me to change the destination address of traffic from my own lan but i'd like to see a sample config

if this works i can forward the new destination address to my firewall and use a service redirect to pass it on to the real address

i think a route map and a nat line pointing to the route map would work

any comments/ideas

thanks to anyone replying

1 REPLY
Silver

Re: NATTING a destination address?

114
Views
0
Helpful
1
Replies
CreatePlease to create content