Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Natting Problems

hi, i have configured the router to dial PPPoE connection and do natting & routing:

ip nat inside source route-map Connection_1 interface Dialer1 overload

ip route 0.0.0.0 0.0.0.0 Dialer1

route-map Connection_1 permit 10

match ip address 1

match interface Dialer1

anyway, everything works fine, except for few strange issues,

such as, when i tun P2P client, the speed become very slow behind the router, if i connect the P2P client directly to the internet, it's very fast.

id like to know why, what causes that natting is not functioning well when i use P2P, while almost all other applications run smoothly?

3 REPLIES
Bronze

Re: Natting Problems

Well, what does your access-list 1 look like?

What router model are you using ?

How much load is there on the processor when using P2P? ("sh proc cpu his")

And do you have firewall features (CBAC/inspect) enable on the router?

New Member

Re: Natting Problems

hi, thanks for reply, here is the ansowers:

access-list 1 permit 192.168.1.0 0.0.0.255

dialer-list 1 protocol ip permit

Router Cisco 3845

the load is not that much, i am currently the only user using it for testing.

cpu < 1% utilization, and memory is almost free.

no firewalls enabled at all at the router..

New Member

Re: Natting Problems

Can you show the full configuration on your router?

124
Views
0
Helpful
3
Replies
CreatePlease login to create content