Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

nbar,bit-rate

Hi,

When I use nbar over subinterfaces fastethernet in a router 2801, it doesn´t work bi-rat and max-bit-rate on the second subinterce:

FastEthernet0/0.1

Input Output

----- ------

Protocol 30sec Bit Rate (bps) 30sec Bit Rate (bps)

------------------------ ------------------------ ------------------------

imap 34000 6000

smtp 11000 0

sna 0 0

ssh 0 0

http 0 0

proxy 0 0

eigrp 0 0

snmp 0 0

dns 0 0

ldap 0 0

unknown 0 0

Total 45000 6000

FastEthernet0/0.2

Input Output

----- ------

Protocol 30sec Bit Rate (bps) 30sec Bit Rate (bps)

------------------------ ------------------------ ------------------------

imap 0 0

smtp 0 0

MS_T_SVR 0 0

sna 0 0

ldap 0 0

ssh 0 0

proxy 0 0

dns 0 0

http 0 0

eigrp 0 0

unknown 0 0

Total 0 0

1 REPLY
Bronze

Re: nbar,bit-rate

Check if you have configured "log-input". If yes, then remove it from the config because packet will not be process switched if we have that configured

115
Views
0
Helpful
1
Replies
CreatePlease login to create content