Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

nbar questions

I enabled nbar protocol-discovery and set up a custom protocol for RDP.  When I run a sh ip nbar protocol-discovery, it shows both input & output data for RDP.  The thing I find strange is for input it has listed, Packet count: 8000, Byte count: 147921, etc.  But for Output it has listed, Packet count: 9000, but then the rest of the entries are zero.  How can that be?  Any ideas?

Thanks,

Mike

1 REPLY
New Member

nbar questions

Please disregard I think I got it.

207
Views
0
Helpful
1
Replies
CreatePlease to create content