Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

NBAR

How can I configure NBAR, I just want to monitor the type of traffic going through a router, I don't want to do QOS with NBAR. Thanks for the help!!

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: NBAR

You can issue the command ip nbar protocol-discovery to turn on nbar for a specific interface. You can then do a show ip nbar protocol-discovery to see the type of traffic that nbar is matching on.

2 REPLIES
Hall of Fame Super Bronze

Re: NBAR

You are looking to configure NetFlow not NBAR, please see the following doc:

http://www.cisco.com/en/US/docs/ios/12_4/netflow/configuration/guide/honf_c.html

HTH,

__

Edison.

Community Member

Re: NBAR

You can issue the command ip nbar protocol-discovery to turn on nbar for a specific interface. You can then do a show ip nbar protocol-discovery to see the type of traffic that nbar is matching on.

633
Views
0
Helpful
2
Replies
CreatePlease to create content