Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need assistance configuring a second two port VWIC card

I have a 2811 with two single T1 VWIC cards bonded together as a multilink. I installed a two port VWIC T-1 card and unable to configure, running configuration shows !card type command needed for slot/vwic-slot 0/2. When I try to configure the card type, I get the following message, Card in slot 2 was removed or does not support command. Show diag shows WIC Slot 2: VWIC2-2MFT.

Help please.

Thanks

1 REPLY
New Member

Re: Need assistance configuring a second two port VWIC card

Think I got it, used the following command, card type T1 0 2

1160
Views
0
Helpful
1
Replies