Need assistance with DWDM configuration on 7600 router
Good morning all,
I have never configured this type of interface yet on a 7600 router and am in need of some assistance. We have 10GE DWDM circuits going in, so we have a XFP-10GLR-OC192SR module in the 7600 for these circuits. THe router has the following controllers listed in the configuration, but I want to make sure I have all bases covered.. any assistance would be GREATLY appreciated!
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...