Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Need example configuration for vwic-1mft-E1(data) on Cisco1760

Hi all,

My company just purchased 2Xvwic-1mft-E1

for Cisco1760. The evironment as follows:

[1760]--[vwic-1mft-E1]--ISP--[vwic-1mft-E1]--[1760]

Could someone please provide me

the example configuration for both

routers ?

Thanks so much : )

2 REPLIES
Gold

Re: Need example configuration for vwic-1mft-E1(data) on Cisco17

Not sure what part you need help with. I will assume just the card itself.

The basic stuff to get started is. (assuming your card is in slot 1/0)

controller e1 1/0

channel-group 0 timeslot 1-31

serial 1/0:0

ip address 1.2.3.4 x.x.x.x

This may be all you need if you are lucky and you can use all the default line encoding and you are not running a fractional e1. All things releated to the csu/dsu function are configured under the controller and the rest is under the serial line.

Re: Need example configuration for vwic-1mft-E1(data) on Cisco17

Hi

Take the following from ur ISP

(1)Time slots alloted to u.

(2)Framing

(3)line code.

The default 2mb unframed settings in my country will be:

controller e1 0

channel-group 0 time-slots 1-31 speed 64

framing no-crc-4

linecode HDB3

clock source line

Then an serial interface will pop up

interface serial 0:0

ip add x.x.x.x x.x.x.x

encap ppp

Revert back if any probs.

Rate if this had helped.

Regards

JD

199
Views
0
Helpful
2
Replies