Need explaination on "show policy-map interface" commands on 4500 and 3560 switches
I have numerous 10 and 100 meg links (WAN/MAN circuits) connecting remote locations(3560's) to a core switch(4507)..I have configured policy maps to support QoS for voice (nope, none Cisco VoIP). I want to see that my policy-maps are being applied/hit/used/functional at both the 4507 and 3560 switches. On any of my 4506 or 4507 switches, I see that the policy-map "has data or packet matches". On any of the 3560 switches, I see no data or packet matches when entering the show policy-map interface command. I am using access-lists for the class-map section in both 4500 and 3560's. The 4500's show "hits/logs" but the 3560's do not. See the output from both the 4507 and 3560 switches. My 4500 switches vary slightly from an IOS perspective as well as the 3560's. Can anyone explain this?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...