Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need help with setting up Cisco 3550 to route to 1841 router

Can someone help me with setting up a Cisco 3550 Layer 3 Switch to route to Cisco 1841 router.

Everyone's tags (1)
13 REPLIES
New Member

Need help with setting up Cisco 3550 to route to 1841 router

Also, I would like assitance with setting up layer 3 routing between Cisco 3550 switches.

Hall of Fame Super Gold

Need help with setting up Cisco 3550 to route to 1841 router

New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router

I have two networks that I need to connect via Cisco 3550 layer 3 switches through their fastEthernet ports. the spoke networks are 10.3.0.0 255.255.0.0 and 10.1.0.0 255.255.0.0. The hub network is 10.2.0.0 255.255.0.0.

New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router

What would the first step be?

New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router

I will not be using routing protocols.

New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router

I plan to:

configure ip routing on the Cisco 3550 switch.

configure a no switchport with an IP Address on the Fastethernet interface leading to the Cisco 1841 router.

Configure default route leading to the Cisco 1841 router.

New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router

How would I connect the other two switches from different networks to the Cisco 3550 layer 3 device connected to the Cisco 1841 router?

New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router


New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router

This what I want to do, or need to do. Setup my Cisco 3550 layer devices to route between locations.

Purple

Need help with setting up Cisco 3550 to route to 1841 router

Hi,

How would I connect the other two switches from different networks to  the Cisco 3550 layer 3 device connected to the Cisco 1841 router? 

connect each access switch with a trunk port going to the core L3 switch,,configure the VLANS on the core then configure a VLAN interface for each VLAN in your network that needs communication.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

Re: Need help with setting up Cisco 3550 to route to 1841 router

hi,

what's your network topology looks like? could you share a brief diagram?

New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router

Hi there.

What are your requirements for this?

Any preference for routing protols, switch config, ip addressing and so forth.



Sent from Cisco Technical Support iPhone App

New Member

Re: Need help with setting up Cisco 3550 to route to 1841 router

To the OP:

Is there any particular reason as to why yu dont want to use RIP/EIGRP/OSPF?

593
Views
0
Helpful
13
Replies
CreatePlease login to create content