Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need NAT help !!!

Hi All

I have two sites A & B connected as below:

A(4507 switch) <-------------> B (2970 switch) <-----> B (2811 router)

Gig port of 4507 switch of Site A is connected to 2970 switch of site B. 2970 switch of site B is connected to 2811 router at same site.

I have created a sub-interface on router. I have assigned /30 IP address on 4507 and on router su-interface. The connectivity is running fine. I am able to ping router from switch and vice versa.

Now, I want to do NAT between sites. The IP pool at site A: 10.10.10.0/24, Pool at B: 192.168.1.0/24, Pool for NAT: 10.10.20.0/24

At site A: I have defined a route for 10.10.20.0/24 towards site B router.

At site B: I have defined a route for 10.10.10.0/24 towards site A switch. Also I have done a static nat of 192.168.1.1 to 10.10.20.1. But I am not able to ping 10.10.20.1 from site A.

My question is, as the sub-interface of the router have incoming and outgoing traffic; what shall I define on it "ip nat inside" or "ip nat outside" or if I am doing something wrong ?

regards/bsn

3 REPLIES

Re: Need NAT help !!!

New Member

Re: Need NAT help !!!

Thanks for replying, but I am not able to co-relate or configure my scenario. Please help.

New Member

Re: Need NAT help !!!

Can somebody help please !!!

107
Views
0
Helpful
3
Replies