Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need to bundle two physical Layer 3 Links

Hi all,

Iam having two FE ports in SPA-8XFE-TX " and the other end is WS-X6148A-RJ-45 ...so how can i bndle these ports in a single logical ports

Thanks in advance

Mahesh K V

2 REPLIES

Re: Need to bundle two physical Layer 3 Links

Hi

You can use a L3 etherchannel.

interface port-channel 1

no switchport

ip address 1.1.1.1 255.255.255.0

then under the physical interfaces

interface range fast0/1 - 2

no switchport

channel-group 1 mode on

the above config needs to be applied on both the devices.

Thanks

Mahmood

New Member

Re: Need to bundle two physical Layer 3 Links

Hi all,

Thanks for the response,but my SPA is not supporting the port-channel configs.Is there is any alternate to achieve the same.

Many Thanks In advance

Mahesh Vijayan

122
Views
4
Helpful
2
Replies