Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need to verify

Hi All

Sorry for the silly question, I problably should know the answer to this but just wanted to make sure. I have an application, RPC that for some reason isn't working. The funny thing is I can ping to the distant end server no problems, can trace route and telnet using ports 135,6001 and 6002. This tells me that I have IP connectivity and so as far as network wise goes all it is good correct? Also just a fyi I have a funky set up where the distant end subnet is split between 2 interfaces I have a static route going out g0/0.100 interface and I have a policy map that directs all the 180s subnet to route out the fa0/1 interface.

1 REPLY
New Member

Re: Need to verify

I know what the problem is...can anyone point me into the right directions on where I can read up on the "ip inspect" command the ones I've found so far are not helpfull.....thank you in advance

389
Views
0
Helpful
1
Replies