Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Netflow for 7600 series

Hi Expert,

I am newbie in this area.

1. We want to use Netflow to monitor MPLS network, is there any specific document for 7600 platform ?

2.Is there any effect on CPU load, interface etc ?

3. Can Netflow monitor specific vlan, vrf or multilink instead of interface ?

Thanks is advance.

8 REPLIES
Gold

Re: Netflow for 7600 series

Is it a public or private MPLS network?

If its public, you can just get data from the CE routers.

CPU load is minimal. Depends on how often you pull flows.

There are some issues with monitoring VRF's.

Netflow is not real product specific, shoulnt be an issue

New Member

Re: Netflow for 7600 series

It is private network. Thank you for your info.

Re: Netflow for 7600 series

Load on cpu is minimal.

There are some layer 2 commands for vlan monitoring. will post them once i find.

u may want to refer this link:

http://www.cisco.com/en/US/docs/ios/12_1/switch/configuration/guide/xcdnfc.html

New Member

Re: Netflow for 7600 series

Hi,

Please send me if you have the documents especially for VLAN and VRF monitoring.

Thanks.

New Member

Re: Netflow for 7600 series

Hmmmm.... If I remember correctly, I don't think NetFlow supports MPLS. I admit I've never used NetFlow before, but from what I've read and heard, NetFlow only works with IP traffic, while in MPLS the IP datagram is encapsulated in an MPLS packet, which NetFlow is still having problems with. Unless, of course, Cisco has "fixed" this limitation...

New Member

Re: Netflow for 7600 series

... I was too quick on the "Post" button...

As far as load goes, as with any feature, you want to make sure that your CPU utilisation is not too high before you enable NetFlow. From talking to Cisco in the past, I remember they mentioned that NetFlow could potentially burden the CPU a bit especially if there is a very large amount of network traffic that it has to "account" for.

New Member

Re: Netflow for 7600 series

Thank you. For CPU load is average 20-30% so we believe it still capable to run Netflow. We also want to short the pull time and cache entries. Anyone want to confirm if Netflow can capture MPLS traffic ?

New Member

Re: Netflow for 7600 series

I did a quick search on Cisco's Feature Navigator. Turns out there is MPLS-aware NetFlow. On Cisco 7600 with Sup 720/MSFC3, this feature is available on the following feature sets:

- Advanced Enterprise Services SSH

- Advanced IP Services

- Advanced IP Services SSH

- IP Services

- IP Services SSH

In all cases, you need IOS version 12.2(33)SRC.

As far as CPU load goes, you're right. There should be plenty of capacity on your router.

204
Views
15
Helpful
8
Replies