network-boot over different ip-segments with old hp-workstation
we have in our factory old hp-workstations, which boot from the network and catch their boot-image from an server. it works fine, when client and server are in the same ip-segment. when we set the client in a differnt ip-segment, nothing works. i analyse the boot-process with wireshark (find the file attached). the client send bootrequests over the rmp (hp remote maintenance protocol) to the server.
my question: is it possible to set a config like "ip-helper" on the interface, behind which the client is, so that all the boot-requests will be send to the correct server?
here is a short layerdescription of the boot-request (see details in the capture-file) --> in the capture-file you have to set this filter:
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...