Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

network connectivity on PIX 515E

I am trying to recover a password on a PIX 515e. I set the interface address, gateway address, server address, and cannot ping the server, cannot see it on the network, etc. I am at a loss. I've never had this problem before.

2 REPLIES
New Member

Re: network connectivity on PIX 515E

How many interfaces are there and which one are you plugged into? Can you ping anything from the PIX?

New Member

Re: network connectivity on PIX 515E

My 525 has 10 interfaces on it but I am only using interface 0 for the recovery. Once I have link to interface 0 then I issue the following commands:

monitor>interface 0

monitor>address 192.168.98.131

monitor>server 192.168.98.130

monitor>file test.bin

monitor>ping 192.168.98.130 (success)

monitor>tftp

The ping, for me at least, only worked from PIX to my tftp server which was directly attached to interface 0 on the PIX (crossover cable). I did receive 20 percent packet loss during the ping which was interesting but the tftp was very fast... I could not ping the PIX from my tftp server. It also only worked if I issued the commands while the link was active.

Hope this helps.

120
Views
0
Helpful
2
Replies
CreatePlease to create content