I have three networks. the ones that are attached 1-2 and 2-3 are connected. I can not ping networks 1 and 3 either way? I tried to put static routes in but will not connect or see each other.. ?? Any Ideas...
There is really not enough information here for us to give you good answers. Would you post the output of show ip interface brief, the configuration of the static routes that you have done, and the output of show ip route?
If we had that (and the identification of the addresses that you are attempting to ping) then we might be able to give you better answers.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...