I have this small network comprising of around 40 users complaining about the poor speed. And they have 2900 WAN router having 10M service. The interesting thing is that they are using proxy server for all the communication.
I am very new to the server side of thing-and wanted to confirm if the proxy server is packed full to its capacity for serving to clients' requests making it slow or its something to do on the network like WAN link being overloaded or showing errors.
I did "sh interface g0/1" (WAN interface) and to me it looks there is not much load as the tx and rxload values are fairly ok. (as shown below). Moreover the output drops is 7341. I am still guessing if thats not too bad??
The other thing I did was to test the "sh ip nat transalations" which is all coming from the PRoxy server and was wondering if that is the place of bottleneck. Currently there were showing around 570 entries. Below are the output from there as well. Also, I was keen to know what is the "----" indicates in some of th output?
CO2900#sh int g0/1
GigabitEthernet0/1 is up, line protocol is up
Hardware is CN Gigabit Ethernet, address is 30e4.dbaa.49a9 (bia 30e4.dbaa.49a9)
Internet address is x.x.x.x/30
MTU 1500 bytes, BW 10000 Kbit/sec, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 7/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Mb/s, media type is RJ45
output flow-control is unsupported, input flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 7341
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...