I am suffering from a big network issues. Don't know what's the cause, my network fails frequesntly with a packet loss for 3, 4 times and ping well for another 20-30 times, it again drops. It repeats frequently. When I shut down the related interface port and issue a no shut command then it works well for about 20-30 minute with no packet drop. What would be the cause ? Please give me some guidelines.
Check the interface for any errors. If you see errors please change the cable with new one. Also check the interface settings like speed, duplex must be same at both ends. Also if the other device is a Server then check the server resource utilizaiton like CPU.
Please rate all the helpfull posts. Regards, Naidu.
Sorry for late reply. My main server is utilizing a maximum memory. Sometimes about 95% Is this the reason. ? But I am facing this type of problem in a specific ISP. I have got sereral ISP's in my LAN. All of the router hit the same server. I am facing this kind of problem in a specific ISP link.
After this type of problem arises I installed another extra two routers in the same network for that ISP with a differnet IP address. In the two router it is not showing so much problem but in another router it is showing a problem. Now, namely I have 3 routers for the same ISP A, B and C. A and B router's link is well. But router C sometimes shows problem. What may be the problem, please help ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.