Could someone please help with the following query.
We are trying to implement a change on our network (please see the attached network diagram).
Please note that the links in red are new links that needs to be implemented. The 2 sites are part of the same logical network and we use different subnets on the 2 sites and all the vlan interfaces are defined on the layer 3 switch on site A and ALL traffic bound for the WAN goes via Firewall 1 and Router 1 using static routes.
We are in the process of adding another link the the WAN as seen on the diagram. The 2 new requirements are:
1. We want traffic from Vlan 30 and 40 bound for the private network to go via the new link (Firewall B and Router B)
2. In case of failure of Router A or Router B, we want all traffic bound for the private network to go via the Router that is up.
Any help implementing these requirements is greatly appreciated.
You might consider to run a routing protocol between 2 sites(all devices) and then adjust path cost on 2 coreswitches to prefer WAN link. In case WAN link's down the coreswitch should use fiber(backdoor) instead.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.