Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Network Sniffer urgent help

guys the satiuation is that i have been told to put network sniffer on router ethernet and capture all the traffic....all i wnat to know is how we will do it....do i have to configure something on the router and what tool i can use.....can someone please provide me whole scenario how i will do it....thanks a million in advance.

1 REPLY

Re: Network Sniffer urgent help

Hello!

You can use the follwing command on the router/switch:

monitor session 2 source "vlan or interface" "rx,tx,both"

monitor session 2 destination "interface"

*where I put " you can hit ? to see what options you have to configure there

on the destination interface you can connect a PC with a packet capture like Ethereal, Wireshark and capture all the packets that you need.

This is the simpliest solution!

Please tell me if you understand!

Cheers,

Calin

89
Views
0
Helpful
1
Replies