Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Network Static NAT

Is there a better way to implement a network static NAT than entering every IP address in the subnet. Its the only way I've found that actually functions properly. (Various versions of 12.4T have functioned differently.)

Current IOS is 12.4(15)T9

2 REPLIES

Re: Network Static NAT

Try this instead:

ip nat inside source static network 192.168.2.0 10.168.16.0 /24 route-map rmap 1

HTH,

John

HTH, John *** Please rate all useful posts ***
New Member

Re: Network Static NAT

route-maps are no longer supported on ip nat inside source static network command

(config)#$de source static network 192.168.2.0 10.1.87.0 /24 ?

extendable Extend this translation when used

mapping-id Associate a mapping id to this mapping

no-alias Do not create an alias for the global address

no-payload No translation of embedded address/port in the payload

redundancy NAT redundancy operation

450
Views
0
Helpful
2
Replies