I have a number of 801 ISDN routers on my network. If I lose power to these devices the internal clock time is reset to default when the device reboots. This causes a problem with my users because we have configured a time range for when the router can dial to connect.
Is there any way I can set an NNTP service that would provide the router with the correct time after a power outage. If there is how do I limit this to get time info 2 or 3 time per day.
Sounds like the easiest way is add another time range that adds the default time to your permitted range. The router should then be able to connect using NTP to reset the clock. Once the clock is reset it would use the other time range. Not sure what the default clock is but they should be all the same for the same router and ios release.
There are plenty of NTP Servers which you can configure as an NTP Server for your Router, and then every time the Router reboots, it will check the time from the NTP Server and synchronize the same with it.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.