I have one question about Network design. We have two datacenter Primary and secondary. we advertised same subnet from Primary and secondary data center but from secondary DC we advertised these subnet with 2 times as prepend so the remote branches which are connected via Service provider using BGP MPLS will always preferred Primary DC. But now we have requirement that one branch will always prefer secondary DC and other braches always prefer Primary DC. What we should do for it
Since you are going through SP MPLS, you have lesser control on outbound route selection..Your traffic will always go to the PE where you have connected. I believe the easiest way to do this with the coordination with Service provider as they have better control for the advertised routes
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...