Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NEXUS 7K - GRE TUNNEL PBR NOT WORKING

Hi,

   I am facing an issue with the PBR configured on GRE tunnel. Traffic path for the next hop configured on PBR is working.Below is the config detail along with trace from the source. Kindly help

Command: show running-config interface Tunnel501
!Time: Wed Aug 29 15:00:37 2012

version 6.0(1)

interface Tunnel501
ip address 10.254.213.246/30
ip policy route-map NEW

tunnel source 10.201.55.1
tunnel destination 10.200.222.1
no shutdown

Route Map config:

CORE1# sh route-map NEW
route-map NEW, permit, sequence 10
Match clauses:
ip address (access-lists): 187
Set clauses:
ip next-hop 10.201.55.5

Trace from source:
L3#traceroute 10.70.2.3 source vlan 856

Type escape sequence to abort.
Tracing the route to 10.70.2.3

1 10.254.213.246 4 msec 0 msec 0 msec
2 10.201.254.34 12 msec 0 msec 4 msec ----> This is my Nexus IP from here as I have configured routemap it should take 10.201.55.5 which is not taking as route map is not working
3 10.200.10.234 0 msec 4 msec 0 msec
4 10.254.242.45 4 msec 4 msec 4 msec
5 10.254.231.174 12 msec 24 msec 12 msec
6 10.142.0.2 16 msec 12 msec 16 msec
7 10.142.254.113 12 msec
10.142.254.2 16 msec 12 msec
8 10.142.254.6 16 msec 12 msec
10.142.254.118 12 msec
9 * * *
10 * * *
11 * *

Regards,

Prakash.K

515
Views
0
Helpful
0
Replies
CreatePlease to create content