The baseline of CPU shown with # is quite low. CPU shown by * are the spikes. To catch those you can run script to be triggered once the spike is hapening. Though this CPU is not that High and we might not get much on the script - though worth trying:
event manager applet highcpu
event snmp oid 126.96.36.199.188.8.131.52.184.108.40.206.1.6.1 get-type exact entry-op ge entry-val 40 poll-interval 1
action 0.1 syslog msg action High CPU DETECTED show process cpu sort written to
action 0.2 cli enable
action 0.4 cli show process cpu sort >> bootflash:highcpu.txt
action 1.0 cli exit
Once it triggered it will collect logs to file bootflash:highcpu.txt. You can than check that file and share here for analysis and further script modification.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.