12-10-2011 02:10 PM - edited 03-04-2019 02:35 PM
Hi Team
I have my DMVPN setup , and i can see my hub from my two spokes and specially my dynamic NHRP mapping is working great in the hub where i can see both spoke but not on the spokes, i only have the dynamic mapping for the hub
I want spoke to spoke traffic to use your NMBA tunnel when there is traffic need to go from spoke to spoke but i can`t do that since NHRP is not mapping my spokes IP on the table (dynamically) and i tried to do statically but it`s not working!
ANy help please ?
12-10-2011 02:51 PM
Hi,
Have a look this document for config example and explanation:
http://blog.ine.com/2008/08/02/dmvpn-explained
HTH
12-11-2011 04:20 AM
What routing protocol are using ?
Can you post the hub config
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: