Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Nhrp Dynamic map for Spoke To Spoke

Hi Team

I have my DMVPN setup , and i can see my hub from my two spokes and specially my dynamic NHRP mapping is working great in the hub where i can see both spoke but not on the spokes, i only have the dynamic mapping for the hub

I want spoke to spoke traffic to use your NMBA tunnel when there is traffic need to go from spoke to spoke but i can`t do that since NHRP is not mapping my spokes IP on the table (dynamically) and i tried to do statically but it`s not working!

ANy help please ?

2 REPLIES
VIP Super Bronze

Nhrp Dynamic map for Spoke To Spoke

Hi,

Have a look this document for config example and explanation:

http://blog.ine.com/2008/08/02/dmvpn-explained

HTH

Re: Nhrp Dynamic map for Spoke To Spoke

What routing protocol are using ?

Can you post the hub config

Sent from Cisco Technical Support iPhone App

343
Views
0
Helpful
2
Replies
CreatePlease to create content