Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NM-1A-T3/E3

Hello,

I am attempting to configure a NM-1A-T3/E3 card in a 2821 route. The router is running 12.4(13r)T IOS with Adv IP Services feature set.

My problem is when I enter config mode to issue the 'card type t3 1' command to initialize the module 'card' is not a valid command.

Anyone come across this before? Any ideas? Should I try a different IOS?

Thanks,

Tom

9 REPLIES
Hall of Fame Super Gold

Re: NM-1A-T3/E3

Can you send output of "show diag" to check if the module is "seen" ?

New Member

Re: NM-1A-T3/E3

Paolo,

Thank you for your reply. Attached is the output you requested.

Thanks,

Tom

Hall of Fame Super Gold

Re: NM-1A-T3/E3

Hi, something is very wrong:

Slot 1:

Unknown (type 1320) Port adapter

Port adapter is disabled

Suggest you replace IOS with any other version of your liking, as sometime they "forget" drivers when making images.

Failing that, contact the TAC and press until they can reproduce the issue, before accepting any HW replacement.

New Member

Re: NM-1A-T3/E3

Thanks for the help. I will follow those suggestions. I was thinking something similar. Wanted to make sure I wasn't missing something.

Tom

Hall of Fame Super Gold

Re: NM-1A-T3/E3

You're welcome. Please remember to rate useful posts.

New Member

Re: NM-1A-T3/E3

Did this end up being an IOS issue? I'm going through the same thing with an NM-1A-T3 card right now in a 2811. However, I suspect there may be a newer card rev as this one was from a 3640.

New Member

Re: NM-1A-T3/E3

Yes it ended up being an IOS issue. The module requires 12.4(15)T or better. I installed 12.4(20)T and so far have had no problems.

Tom

New Member

Re: NM-1A-T3/E3

Tom,

Thanks for the reply. Is that IPBase or a different version?

Thanks.

New Member

Re: NM-1A-T3/E3

I ended up getting Adv. IP Services. Needed BGP routing for this router.

497
Views
4
Helpful
9
Replies