NM-1T3/E3 in down state after reload or cable is disconnected
I have a T3+ PA 1 port adapter in a 7304 and NM1T3/E3 in a cisco 3745.
If the interface goes down by an alarm or cable disconnection, it never recovers itself. Also reboot does not help.Only work-around is to remove "card type t3" , reboot router and reenter "card type t3 " command on the 3745 router.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.