Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NM-1T3/E3 serial problem

Dear All,

        when i connecting serial cable on S0/1 on this router , the ping delay is very high and then s0/1 is up down although the same link working on another router without any problem.

1 REPLY
Hall of Fame Super Silver

Re: NM-1T3/E3 serial problem

Hello Ibrahim,

my first note is that your module is

a subrate E3 not a full E3 you may be using the wrong network module if this is supposed to be a full rate E3

from sh ver in your sh tech

1 Subrate T3/E3 port

everywhere in your configuration you suppose to have a full rate E3 and for example you have configured bandwidth 34000.

SUBRATE FPGA Registers (Clear T3/E3):

! we can see also errors in the sh controller output:

278170 rxintr, 268183 txintr, 19559815 rxerr, 0 txerr
0 mpsc_rx, 1261 mpsc_rxerr, 0 mpsc_rlsc, 0 mpsc_rhnt, 0 mpsc_rfsc
0 mpsc_rcsc, 1261 mpsc_rovr, 0 mpsc_rcdl, 0 mpsc_rckg, 0 mpsc_bper
0 mpsc_txerr, 0 mpsc_teidl, 0 mpsc_tudr, 0 mpsc_tctsl, 0 mpsc_tckg
0 sdma_rx_sf, 0 sdma_rx_mfl, 0 sdma_rx_or, 0 sdma_rx_abr, 0 sdma_rx_no
0 sdma_rx_de, 0 sdma_rx_cdl, 0 sdma_rx_ce, 0 sdma_tx_rl, 0 sdma_tx_ur
19559815 sdma_rx_reserr, 0 sdma_tx_reserr

Also even if the network module can be used as full rate E3 it is not recommended to put it inside a PPP multilink bundle.

I would suggest you to use the E3 link as a L3 interface on both sides, because in this way the load on the router is lower.

Hope to help

Giuseppe

545
Views
0
Helpful
1
Replies