Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NM 2W with WIC-1DSU-T1 not recognized

I just added a NM 2W card to my 2621, with a WIC-1DSU-T1 card, and it is not showing up as an available interface. The NM 2W card had the 'en' light on at startup, but now no lights, and it does not appear available. Do I need to do something else to enable it?

3 REPLIES
Hall of Fame Super Bronze

Re: NM 2W with WIC-1DSU-T1 not recognized

The WIC-1DSU-T1 is a v1 or v2 card?

If V2, you need a 2600XM router, not a regular 2600 router. Also, what IOS release version you are running?

__

Edison.

New Member

Re: NM 2W with WIC-1DSU-T1 not recognized

It's a v1 card, same as two other WIC's I'm using in the built in slots.

IOS is version 12.0(7)T.

Hall of Fame Super Bronze

Re: NM 2W with WIC-1DSU-T1 not recognized

Try upgrading the IOS version.

182
Views
0
Helpful
3
Replies