Cisco Support Community
Community Member

NM-CEM-4SER real life experience

Please does anyone have real life experience implementing the above module on any Cisco router ? I'm doing so presently, but the performance has not been consistent, to say the least.

Hall of Fame Super Gold

Re: NM-CEM-4SER real life experience

In the past someone has mentioned here some problem, was directed to the TAC, never heard anymore. Which exact IOS are you testing with ?

Community Member

Re: NM-CEM-4SER real life experience

I'm running C3845-SPSERVICESK9-M. Version 12.4(15)T1. My setup is as below;

BERT tester------3845 router with CEM-----Satellite modem(remote location)------------------------------------(teleport)Satellite modem---3845 route with CEM with network loop.

My BERT test runs clean on one port at 2MB, but generates tons of erros if try another port on 2MB. It runs clean if run the other port on less than 2MB, say 1MB.

Any ideas anyone ?

Hall of Fame Super Gold

Re: NM-CEM-4SER real life experience

Sorry I can't offer any real experience but the fact that just moving the circuit from one port to another degrades the performances, makes one think it's a problem with the product itself. Suggest you seek help from the tac, don't let the case to the engineer on duty, ask for immediate escalation to the product-specific team.

CreatePlease to create content