I am having difficulties configuring the second port of a VWIC2-2MFT-T1/E1 that is in the first slot of a NM-HD-2VE network module. I have the first port configured for a data T1 and it is working fine. Here is the config for that port:
card type t1 1 0
no network-clock-participate slot 1
controller T1 1/0/0
cablelength short 133
channel-group 0 timeslots 1-24
detect v54 channel-group 0
ip address 172.26.199.37 255.255.255.252
When I configure the controller for the second port of the VWIC I get an error when I define the channel-group.
%Insufficient resources to create channel group
I have 3 other 2 port T1 VWICs installed in the HWIC slots and they are working fine.
When independent clocking is configured, the controller will support only one channel group and no voice applications. If more than one channel group is configured, the following error message occurs "%Insufficient resources to create channel group"
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...