Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NM1 T3/E3 configuration

I like the url for a basic configuration for a new DS3 card in my router please.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: NM1 T3/E3 configuration

Here you go:

http://cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/serial/pa-t3_serial_install_config/3504conf.html

Even if your router is not the onle listed, commands are the same.

Hope this helps, please rate post if it does!

5 REPLIES
Hall of Fame Super Gold

Re: NM1 T3/E3 configuration

Here you go:

http://cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/serial/pa-t3_serial_install_config/3504conf.html

Even if your router is not the onle listed, commands are the same.

Hope this helps, please rate post if it does!

New Member

Re: NM1 T3/E3 configuration

I checked this url and it is referencing a serial interface. The card I have is in a 3845 router. The card is a NM1-T3/E3 DS3 card that has a transmit and receive coax connections. The card is in the router and the green light is on solid for enable. When I look for the interface on the router it is not there. I assume this is because there is currently no cables connected to it. I would like to get a basic configuration for this as it is being connected to AT&T for our WAN interface.

New Member

Re: NM1 T3/E3 configuration

I noticed the url posted refers to a PA/T3. Is this the same as a NM1-T3/E3 DS3 card?

Hall of Fame Super Gold

Re: NM1 T3/E3 configuration

Hi, please configure "card type T3 ", after that the interface will appear and you will be able to configure.

If still trouble, please post "show ver" and "show diag".

New Member

Re: NM1 T3/E3 configuration

Thanks guys. Great help.

410
Views
0
Helpful
5
Replies