01-23-2008 06:33 AM - edited 03-03-2019 08:23 PM
I like the url for a basic configuration for a new DS3 card in my router please.
Solved! Go to Solution.
01-23-2008 06:39 AM
Here you go:
Even if your router is not the onle listed, commands are the same.
Hope this helps, please rate post if it does!
01-23-2008 06:39 AM
Here you go:
Even if your router is not the onle listed, commands are the same.
Hope this helps, please rate post if it does!
01-23-2008 06:50 AM
I checked this url and it is referencing a serial interface. The card I have is in a 3845 router. The card is a NM1-T3/E3 DS3 card that has a transmit and receive coax connections. The card is in the router and the green light is on solid for enable. When I look for the interface on the router it is not there. I assume this is because there is currently no cables connected to it. I would like to get a basic configuration for this as it is being connected to AT&T for our WAN interface.
01-23-2008 06:44 AM
I noticed the url posted refers to a PA/T3. Is this the same as a NM1-T3/E3 DS3 card?
01-23-2008 08:29 AM
Hi, please configure "card type T3
If still trouble, please post "show ver" and "show diag".
01-23-2008 12:15 PM
Thanks guys. Great help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: