Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

No double NAT (LAN->WAN->DMZ)

Hi!

We have got the following Issue:

NAT from LAN to (external) Public WAN-Addresses is working fine.

NAT from LAN to (internal) Router Hosted Public DMZ WAN-Addresses (NAT LAN-Interface -> WAN-Interface -> DMZ-Interface) is not working!

The Router performs no NAT, obviously because of the public IP is hosted from the router themselve, so the Router tries to route the packets direktly without any NAT from LAN->DMZ.

Are there any workarounds (perhaps to trigger LAN-Hosts to performed NAT in any case?

Thanks!

1 REPLY
Silver

Re: No double NAT (LAN->WAN->DMZ)

Hi! We have got the following Issue: NAT from LAN to (external) Public WAN-Addresses is working fine. NAT from LAN to (internal) Router Hosted Public DMZ WAN-Addresses (NAT LAN-Interface -> WAN-Interface -> DMZ-Interface) is not working! The Router performs no NAT, obviously because of the public IP is hosted from the router themselve, so the Router tries to route the packets direktly without any NAT from LAN->DMZ. Are there any workarounds (perhaps to trigger LAN-Hosts to performed NAT in any case? Thanks!

289
Views
0
Helpful
1
Replies