Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

No internet connectivity with Cisco 2504 Wireless controller

Hello all, 

I am currently attempting to set up the 2504 WLC with two 3502i APs. The network itself works fine, but there is not internet connectivity once connected to the network. 

(Cisco Controller) >show sysinfo

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 7.6.100.0
Bootloader Version............................... 1.0.18
Field Recovery Image Version..................... 1.0.0
Firmware Version................................. PIC 16.0


Build Type....................................... DATA + WPS

System Name...................................... Cisco_47:07:04
System Location..................................
System Contact...................................
System ObjectID.................................. 1.3.6.1.4.1.9.1.1279
IP Address....................................... 10.1.10.118
Last Reset....................................... Software reset
System Up Time................................... 0 days 0 hrs 59 mins 48 secs
System Timezone Location.........................
System Stats Realtime Interval................... 5
System Stats Normal Interval..................... 180


--More-- or (q)uit
Configured Country............................... US  - United States
Operating Environment............................ Commercial (0 to 40 C)
Internal Temp Alarm Limits....................... 0 to 65 C
Internal Temperature............................. +23 C
External Temperature............................. +29 C
Fan Status....................................... 3600 rpm

State of 802.11b Network......................... Enabled
State of 802.11a Network......................... Enabled
Number of WLANs.................................. 1
Number of Active Clients......................... 1

Burned-in MAC Address............................ 24:E9:B3:47:07:00
Maximum number of APs supported.................. 5

 

Please advise. 

Regards, 
Alex

  • WAN Routing and Switching
Everyone's tags (1)
1 REPLY
New Member

Assuming since you said the

Assuming since you said the network was working fine, your client connects, obtains and IP address and can ping it's gateway?

If so that I would look at your router most likely and review NAT. Perhaps your WiFi is on a separate subnet and you don't have a NAT statement to translate that subnet and give them external access. Of course there could always be a firewall in place as well preventing it, but there are just some generic ideas to give you a start.

 

417
Views
0
Helpful
1
Replies
This widget could not be displayed.