I'm not sure if this is the right support area or not but here goes. I have a SA520, vs.2.1.71. My problem is this. Under a Static IP with Protectlink's Overflow Control, Web Protection and URL Filtering enabled, I cannot view any web site. If I change the Static IP to Dynamic IP, it all works with everything enabled, but as soon as I select Static, nothing. I've even tried different browsers. No matter what web page I look at under Static IP it says this: "The URL you are attempting to access has been blocked. Your organization's policy prohibits accessing this Web site."
ProtectLink is registered and under Networking it indicates all the Static setup is ok and the DNS is displaying the proper addresses.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...