Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No performance data for service module

When issuing a 'show service-module s0/1' I never have any data in the performance counters. It's always (last 0 15 minute intervals).

WIC is a 4wire T1 with a 768IBR frame ckt.

Router is a 2600 series.

Is there a way to enabel this?

************************

Total Data (last 0 15 minute intervals):

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Data in current interval (0 seconds elapsed):

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

2 REPLIES
Gold

Re: No performance data for service module

This is good news. A clean wan link.

Try show interface s0/1. thats where you will find some numbers.

New Member

Re: No performance data for service module

Actually, the T1 had taken many los, lof in past 2 hours when I took a snapshot of the Total Data info. The (last 0 15 minute interval) never changes. Always shows 0 15.

122
Views
0
Helpful
2
Replies