cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
247
Views
0
Helpful
1
Replies

No trans on vlan int

rhltechie
Level 1
Level 1

Hi all,

back again about my router int and a vlan. i have the following set:

interface FastEthernet0/0

no ip address

speed 100

full-duplex

!

interface FastEthernet0/0.300

encapsulation dot1Q 300

ip address <ip> 255.255.255.252

rate-limit output 10000000 250000 250000 conform-action transmit exceed-action

drop

no cdp enable

!

my provider cannot see me or vice versa. when i do a "show vlans" my transmitted never goes up unless i ping my own interface. am i missing something?

TIA,

R

1 Reply 1

j-block
Level 4
Level 4

Use the show vlan command show vlan [{brief | {id vlan-id} | {name name} [ifindex]} | ifindex] where brief displays only a single line for each VLAN, naming the VLAN, status, and ports.This sould give more insight.For more refer the following

http://www.cisco.com/en/US/products/hw/routers/ps368/products_command_reference_chapter09186a00801027af.html to get some clue.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco