Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

no voice stream after call connected.

In my cisco callmanager4.2 environment,one 7940 ip phone located in remote branch ,connected through leased line.Now i facing issue with no voice stream after call is connected .I checked the connectivity and its ok.No firewall is blockig RTP stream...Please give me solution...

1 REPLY
New Member

Re: no voice stream after call connected.

I had a similar situation. Even without a firewall, do you have any ACL's on the switches or any other link. If we look at the call flow it might make more sense.

Phone calles Call Manager to initiate call - Call manager calls the end phone. Once the call is initiated it hands it off and the two devices communicate directly.

If you have any ACL's that allow the phones to talk to the call manager, you will also need to allow all other subnets that have voice traffic.

When I was trying to troubleshoot the issue I was having, I really began to understand the flow of the conversation. I also experienced one way communications.

Phone connects to call manager, call manager dials number, hands off communications and one phone could hear the other, but an ACL was only blocking the traffic from the remote site into the main site, but the main site had free access to the remote site. I hope this helps.

109
Views
0
Helpful
1
Replies